Directed Electronics Automate 210D Provozní pokyny stáhnout pdf (Strana 35)

The balance offers you various calibration and

linearization functions.

You can interrupt any calibration or linearization

procedure by pressing the c key (32).

In the fully automatic mode, the draft shield closes

after the f or the t key has been pressed.

Important Note:

! During calibration or linearization, you must observe

the following:

– Unload the weighing pan

– Do not disconnect the balance from AC power

– Do not unplug the connecting cable

Important Note to Users of Verified Balances

Approved for Use as Legal Measuring Instruments:

Internal Calibration

CAL Function Using the f Key:

Unload the pan and tare (if necessary, close the

draft shield).

When the balance shows a zero readout, press the

f key (21).

“C” will now be displayed. The built-in calibration

weights are internally applied by servomotor and

removed at the end of calibration.

If external interference affects the calibration

procedure, you may obtain a brief display of the error

message “Err 02.”

In this case, tare and then press the f key again

when a zero readout appears.

An acoustic signal indicates the end of calibration.

Before using your balance as a legal measuring

instrument, you must carry out the internal calibration

function at the place of installation (see below).

1–31

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 187 188

Žádné komentáře

Directed Electronics Automate 210D Provozní pokyny Strana 35