Directed Electronics S 580 E Uživatelská příručka stáhnout pdf (Strana 41)

Operation 35

Figure 3-15 Heater Control Window

4. Activate the heater by double clicking the icon in the On/Off column until the heater loop

icon

turns yellow and red.

 NOTE To change heater temperature, double click on the heater loop name. The Heater

Parameters dialog box will open.

 The heater is operating properly if both of the following are observed:

- The Message column contains any message except “T/C Break”.

- The present value (PV) column indicates the heater is heating up to, and stabilizing

at, the temperature set point (SP).

5. If the heater is operating properly, click on Exit to close the Heater Control Window. If it is

not operating properly, refer to Section 1 - Introduction or call a service technician.

Message

Column

Heater Loop

OFF

Channel (Loop)

Name Column

Temperature Set

Point Column

Present Temperature

Value Column

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

Žádné komentáře

Directed Electronics S 580 E Uživatelská příručka Strana 41