Directed Electronics Valet 561T Instalační příručka stáhnout pdf (Strana 5)

Remove any paint and connect this wire to bare metal, preferably with a factory bolt rather than a screw. (Screws

tend to strip or loosen with time.) We recommend grounding all components, including the siren, to the same point.

This wire is used in vehicles that have a positive (+) switched domelight circuit. Connect the violet wire to a

wire that shows (+)12V when any door is opened, and ground when the door is closed. This wire will report Zone 3.

This wire will respond to a negative input with an instant trigger. Inputs shorter than 0.8 seconds will trigger

the Warn Away response, while triggers longer than 0.8 seconds will instantly trigger the full alarm cycle. This

wire is ideal for hood and trunk pins and will report on Zone 1. This wire can also be used with Directed

Electronic’s 506T Glass Breakage Sensor, as well as other Directed Electronic’s single stage sensors. The H1/7 BLUE

multiplex trigger wire can be used to shunt sensors during operation, using the auxiliary channels. When any of

the auxiliary channels are transmitted, the H1/7 BLUE wire monitors for a ground. If ground is detected within

5 seconds of transmission, the sensors and the multiplex trigger input on the BLUE wire will be shunted until 5

seconds after the ground is removed. This allows the customer to access the trunk, remote start the vehicle, or

roll the windows down without first disarming the alarm. (See

Bypassing Sensor Inputs

section of this guide.)

HH11//77 BBLLUUEE ((--)) mmuullttiipplleexx ttrriiggggeerr iinnppuutt,, zzoonnee 11

HH11//66 VVIIOOLLEETT ((++)) ddoooorr ttrriiggggeerr iinnppuutt,, zzoonnee 33

HH11//55 BBLLAACCKK ((--)) cchhaassssiiss ggrroouunndd ccoonnnneeccttiioonn

TO IGNITION SYSTEM

H1/4 YELLOW

PRIMARY HARNESS

1 2 3 4 5 6 7 8 9 10 ... 33 34

Žádné komentáře

Directed Electronics Valet 561T Instalační příručka Strana 5