Directed Electronics Valet 561T Instalační příručka stáhnout pdf (Strana 4)

IIMMPPOORRTTAANNTT!!

Never use this wire to drive anything but a relay or a low-current input! The tran-

sistorized output can only supply 200 mA of current. Connecting directly to a solenoid, motor,

or other high-current device will cause it to fail.

Before connecting this wire, remove the supplied fuse. Connect to the positive battery terminal or the constant

12V supply to the ignition switch.

NNOOTTEE::

Always use a fuse within 12 inches of the point you obtain (+)12V power. Do not use the

15A fuse in the harness for this purpose. This fuse protects the module itself.

Connect this to the red wire of the siren. Connect the black wire of the siren to (-) chassis ground, preferably at

the same point you connect the control module’s black ground wire.

Connect this wire to an ignition source. This input must show (+)12V with the key in run position and during

cranking. Make sure that this wire cannot be shorted to the chassis at any point. This wire will report Zone 5.

HH11//44 YYEELLLLOOWW ((++)) iiggnniittiioonn iinnppuutt,, zzoonnee 55

BROWN H1/3

(+) 12V SIREN OUTPUT

RED

BLACK

HH11//33 BBRROOWWNN ((++)) ssiirreenn oouuttppuutt

HH11//22 RREEDD ((++))1122VV ccoonnssttaanntt ppoowweerr iinnppuutt

H1/1 RED/WHITE

(+) 12V CONSTANT FUSED

87A

(+) 12V IF (+) SWITCHED

(-) GROUND IF (-) SWITCHED

SWITCHED TRUNK

RELEASE WIRE

1 2 3 4 5 6 7 8 9 ... 33 34

Žádné komentáře

Directed Electronics Valet 561T Instalační příručka Strana 4