Directed Electronics 554A Provozní pokyny stáhnout pdf (Strana 23)

TM 11-6625-2611-12

Figure 3-2. Low power measurement calibration chart

Section Il. OPERATION UNDER USUAL CONDITIONS

AND

PREPARATION FOR

3-3. Preliminary Starting Procedure

No special starting procedures are necessary other

MOVEMENT

a. Disconnect all

interconnecting cables from both

the test set and equipment connected to the test set.

than setting POWER ON/OFF switch to ON.

b. Disconnect power cable from test set and power

3-4. Procedure for Shutdown

source.

No special stopping procedures are necessary other

C. Store all cables, adapters, attenuators, loads, and

than setting POWER ON/OFF switch to OFF.

chart in front panel cover.

3-5. Preparation for Movement

d. Install front panel cover to test set.

Prepare the test set for movement as follows:

Table 3-1. Operator’s Controls, Indicators, and Connectors

3-3

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 58 59

Žádné komentáře

Directed Electronics 554A Provozní pokyny Strana 23