Directed Electronics Viper ESP 540 Instalační příručka stáhnout pdf (Strana 103)

Do not disconnect the battery if the vehicle has an anti-theft coded radio. If equipped

with an airbag, avoid disconnecting the battery if possible.

IIMMPPOORRTTAANNTT!!

Please read this entire installation guide before beginning the installa-

tion. The installation of this security system requires interfacing with many of the vehi-

cle’s systems. Many new vehicles use low-voltage or multiplexed systems which can

be damaged by low resistance testing devices, such as test lights or logic probes. Test

all circuits with a high-quality digital multi-meter before making the connections.

MMPPOORRTTAANNTT!!

Many airbag systems will display a diagnostic code through their warn-

ing light after they lose power. Disconnecting the battery requires this code to be

erased, a procedure that can require a trip to the dealer.

before beginning the installation:

Check with the customer to determine the LED and Valet switch locations.

Remove the domelight fuse. This prevents accidentally draining the battery.

Roll down a window to avoid being locked out of the car.

after the install:

Test all functions. The “Using Your System” section of the Owner’s Guide is very

helpful when testing.

When testing, don’t forget that this system is equipped with Nuisance Prevention

Circuitry.

NPC

™

can bypass both sensor zones, making them seem to stop working.

Carefully reassemble the under-dash trim panels.

Inspect the engine compartment for tools that may have been left behind.

tools required

This is a general list of tools required to complete the installation of this security sys-

tem in most vehicles. Some vehicles may require additional tools.

Digital multi-meter

Nutdriver and/or socket set

Wire cutters/strippers

Panel removal tool

N427V_05-05.qxd 6/8/2005 12:37 PM Page 4

25-Mar-10

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 177 178

Žádné komentáře

Directed Electronics Viper ESP 540 Instalační příručka Strana 103