Directed Electronics AutoCommand 25622 Instalační příručka stáhnout pdf (Strana 39)

Last Start Diagnostics:

The system holds in memory the reason for the most recent

remote start activation. This diagnostic report must be recalled

using the following operation:

1. Turn the ignition ON and then OFF in less than 5 seconds

2. Within 5 seconds press and release the Momentary

Switch

3. After 2 seconds the LED will flash/pause and repeat 5

times to indicate the cause of the most recent remote

start activation.

4. Count the LED flashes and consult the Last Start

Diagnostic Chart

Last Start Diagnostic Chart

LED

Flashes

Description

1 The Remote Starter has not been activated since the main power

was connected

2 No Diagnostic

3 The Activation Input wire was used to activate the Remote starter

4 Low temperature activated the Remote Starter in Vacation Mode

5 Low battery voltage activated the Remote Starter in Vacation Mode

6 No Diagnostics

7 Daily Start activated the Remote Starter

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 56 57

Žádné komentáře

Directed Electronics AutoCommand 25622 Instalační příručka Strana 39