Directed Electronics AutoCommand 25622 Instalační příručka stáhnout pdf (Strana 15)

Step 1, Heavy Gauge Wire Connections

Ground Wire

The BLACK wire connects to the pin next to the light flash jumper

fuse. First strip back a ¾-inch section of the insulation off the

BLACK wire and crimp a ring terminal (not provided) to that wire.

Locate a clean, paint-free metal surface in the drivers kick panel

(do not ground on dash). Using a self-tapping screw, drill the

screw with the ring terminal to the kick panel. Once screwed down,

pull on the wire to ensure a good connection.

Constant Power and Ignition wires

Almost all your power and ignition wires can be found behind the

key cylinder under the lower driver's side dash panel. Using the

appropriate hand tools, remove the lower dash panel taking care

not to break any parts. If the panel does not come off easily, check

for any additional screws you may have missed.

note! More problems are attributed to poor ground

connections than any other cause. Take extra care

to ensure the ground is a clean metal-to-metal

contact and secure.

SELF-TAPPING

BOLT OR SCREW

RING

TERMINAL

GROUND

WIRE

NOTE: REMOVE ANY PAINT

BELOW RING CONNECTOR

DIA-591

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 56 57

Žádné komentáře

Directed Electronics AutoCommand 25622 Instalační příručka Strana 15