Directed Electronics RSIII Instalační příručka stáhnout pdf (Strana 10)

2002

Directed Electronics, Inc.

H1/6 BLUE (-) Multiplexed Trigger Input, Zone 1 and Trunk Icon

This input will respond to a negative input with a WarnAway

or instant trigger. It is ideal for hood

and trunk pins and will report on Zone 1. It can also be used with Directed dual-stage sensors. The

H1/6 BLUE WarnAway

or instant trigger wire can also be used to shunt sensors during operation of

auxiliary channels or remote start. (See Bypassing Sensor Inputs section of this guide.)

H1/7 VIOLET (+) Door Trigger Input, Zone 3 and Door Icon

This type of dome circuit is used in many Ford products. Connect the VIOLET wire to a wire that

shows (+)12V when any door is opened. This wire will report Zone 3.

NOTE: If using a door trigger wire that has a delay, Advanced Menu 2, feature 6, or the 998T

Bitwriter can be used to turn Bypass Notification off.

H1/8 BLACK (-) Chassis Ground Connection

Connect this wire to a clean, paint-free sheet metal location (driver kick panel) using a factory bolt

that DOES NOT have any vehicle component grounds attached to it. A screw should only be used

when in conjunction with a two-sided lock washer. Under dash brackets and door sheet metal are

not acceptable ground points. It is recommended that all security components be grounded at the

same location.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Žádné komentáře

Directed Electronics RSIII Instalační příručka Strana 10