Directed Electronics Valet 561T Instalační příručka stáhnout pdf (Strana 14)

1144

This input comes from the factory set to 2 activation pulses. This means that it is necessary to have 2 consecu-

tive 12V pulses on the white/blue wire for the remote start to activate or to deactivate. The same holds true for

the remote control activation when set to a two pulse setting it is necessary to press the button twice for

the remote start to activate or deactivate.

NNOOTTEE::

When the activation pulse count can be programmed to 1, 2, or 3 pulses when changed it

will affect both activation inputs; the White/Red wire and the remote control activation.

When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the RED/WHITE wire will

supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or

other relay-driven function.

IIMMPPOORRTTAANNTT!!

Never use this wire to drive anything except a relay or low-current input! The transistorized output

can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other high-current device will

cause it to fail.

HH11//77 RREEDD//WWHHIITTEE CChhaannnneell 22,, ((--)) 220000 mmAA oouuttppuutt

HH11//66 WWHHIITTEE//RREEDD ((++)) aaccttiivvaattiioonn iinnppuutt

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 38 39

Žádné komentáře

Directed Electronics Valet 561T Instalační příručka Strana 14