Directed Electronics Automate 210D Instalační příručka stáhnout pdf (Strana 17)

Once you have identified the correct wire, solder the WHITE

wire on the main connector to it and cover the connection with

electrical tape.

step 6

Door triggers

The door trigger is the circuit in the vehicle that tells the dome

light to come on when the door is opened. This wire can be

either a positive 12 volt polarity or more commonly a negative

ground polarity, the door trigger wire is mandatory for all secu-

rity systems and can usually be identified on

www.diyrattler.com. Using the information sheet for your

specific vehicle locate the suspect wire, if the door trigger listed

for your car is a negative type door trigger place the red lead of

your meter to a constant 12 volt source and secure it, take the

➜

iimmppoorrttaanntt::

While reading the meter turn (adjust) the

dash dimmer control switch. The voltage should not vary

on the meter. If the voltage does vary the incorrect sus-

pected wire has been tested. Find the correct wire and

retest.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 54 55

Žádné komentáře

Directed Electronics Automate 210D Instalační příručka Strana 17