Directed Electronics 381 Series Instalační příručka stáhnout pdf (Strana 7)

H1/8 BLACK

(-) chassis ground connection: Connect this wire to bare metal, preferably with a factory bolt rather

than your own screw. Screws tend to either strip or loosen with time. We recommend grounding all your compo-

nents, including the siren, to the same point in the vehicle.

H1/9 YELLOW

(+) ignition input: Connect this wire to the +12V ignition wire. This wire must show +12V with the key

in run and crank position. Take care to insure that this wire cannot be shorted to the chassis at any point.

H1/10 BROWN

(+) siren output: Connect this to the RED wire of the Revenger

siren. Connect the BLACK wire of the

siren to (-) chassis ground, preferably at the same point you connect the control module’s BLACK ground wire.

H1/11 RED

(+)12V constant power input: Before connecting this wire, remove the supplied fuse. Connect to the

battery positive terminal or the constant 12V supply to the ignition switch.

NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A fuse in the har-

ness for this purpose. This fuse protects the module itself.

H1/12 RED/WHITE

high current output from on-board Channel Two (trunk release) relay: Whenever the button(s)

controlling Channel Two is pressed for 1.5 seconds, the on-board relay is activated and will stay activated as long

as the transmission continues. This relay is often used for trunk release. The relay can drive circuits up to 20

amperes.The polarity of this output is determined by the connection of the input wire (H2/A) in the Door Lock Harness.

NOTE: If the input wire (H2/A) is not connected, there will be no output from the relay when it is activated.

Relay Harness, 8-pin harness

H2/A RED/WHITE

input to on-board Channel Two (trunk release) relay: This wire is used to supply voltage to the

output (H1/12). If you want a positive output on H1/12, connect this wire to +12V. Always fuse appropriately. If a

negative output is desired, connect this wire to chassis ground.

H2/B BLACK/WHITE

input to domelight supervision relay: This wire determines what the output polarity of H1/4

will be. If the door pin circuit is negative, connect to chassis ground. If the door circuit is positive, connect to a fused

12V source.

H2/C - H2/H POWER DOOR LOCKS

The system has door lock relays on-board, and can directly interface with

most electric power door lock systems drawing 30 amps or less. It can also drive aftermarket actuators directly.

(Some vehicles require that an aftermarket actuator be added to the driver’s door to allow system control, see Type

D wiring).

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Žádné komentáře

Directed Electronics 381 Series Instalační příručka Strana 7