Directed Electronics D800 Uživatelský manuál

OWNERS MANUAL SUBAL ND800 UNDERWATER HOUSING for Nikon D800

10 Before closing the housing please take care for the following points: The LOCK switch must be NOT activated The switches “Photo/Video” and

11THE INTERCHANGEABLE PORT SYSTEM For your SUBAL housing, there is a wide range of front ports available, the largest of all manufacturers. This all

12 DOMEPORTS Domeports are ports with a curved front glass. They are mainly used with wide angle lenses to keep the same angle of coverage under wate

13OPERATING THE FUNCTIONS The operation of the camera functions is the same as for surface use: By pressing the corresponding levers, push buttons

14MOUNTING AND CONNECTING A FLASH UNIT The SUBAL ND800 is equipped with 2 glass ports to connect Sea&Sea fiber optic cables. Adapters for ot

15 WARNING! The socket is not waterproof with the plug removed. The red blanking plug must be screwed into the socket(s) if the housing is used

16 CHECK-LIST After ensuring that the main O-ring has been installed and the housing closed properly, please check carefully ONCE AGAIN, whether:

17GUARANTEE DURATION OF GUARANTEE: SUBAL ND7000 underwater housings are guaranteed against defects in material or workmanship for two full years fro

2We congratulate you on your choice of the SUBAL ND800 underwater housing for the Nikon D800. During the conception and design of the housing, cons

3GENERAL Warning! It will be assumed that the user of the camera is fully confident and trained in the use of diving equipment. The demands on under

4USE AND MAINTAINANCE OF O-RINGS SUBAL housings are designed to use specially formulated O-rings. Replacement by other than genuine SUBAL O-rings ma

5 PREPARING THE CAMERA There is nothing to change on your Nikon D800 for the use with SUBAL ND800 Knowledge and familiarization with the functions

6OPENING THE HOUSING It is recommended to rinse the housing with fresh water and dry before opening. When rinsing the housing make sure the port is

7 INSERTING THE CAMERA In order to facilitate the fitting of the camera into the housing, please take note for the following hints: Open the housin

8 Also the FN lever Put the housing on the front of the port. Take the camera and align the support saddle with the mounting rails inside the hous

9 Now the AF/M schwitch has to be re-positioned. Put the outside pear-shaped lever in position AF (if the camera is set to this) and push it in the d